Liquid Crystal® Mood Paint® (6 Color) - Thermochromic Ink (Mood Ring Effect)

Please, Read All Information Below Before Placing Your Order!

Product: Liquid Crystal® (6 Color) - Thermochromic Ink,  Mood Paint®

Color: Colors resemble shades of: 

Black, Brown, Red, Green, Blue, Purple

Effect: "Mood Ring" Effect - Changes Multiple Colors Between 80ºF and 90ºF

Particle Size: Liquid Form

Amount: 10g Pure Form, 1 fl oz Concentrate

Description:

Liquid Crystal® is a specialty material that changes colors multiple times within a window of activation temperatures - just like in a mood ring! 

This 6 Color Liquid Crystal® will change colors resembling Black, Brown, Red, Green, Blue, and Purple between the temperatures of 80ºF and 90ºF.

This specialty material can be used on a variety of different projects, but be careful to follow the instructions listed here on the website and on the product packaging - this product can be easily damaged if used incorrectly, resulting in a project that will no longer change colors.

*Recommended for use on Artificial Nails only if being used for Nail Art! Pure Form works best for nail application.*

Instructions for Use:

DO NOT MIX LIQUID CRYSTAL® WITH ANY OTHER MEDIUMS! This will damage the product, and you will not be able to achieve the desired effect!

Liquid Crystal® must be applied directly to a dry black surface.

Apply thin coats, drying each layer before adding the next.

Seal with a tested and approved clear coat - Clear Epoxy Resin or Model Master Enamel both work well.

Shake Well Before Use!

• Pure Form - Best for use in Nail Art and brushing onto small projects.
  • Start with a dry black surface.
  • Apply a thin coat of Liquid Crystal® with a brush.
  • Dry with hair dryer or heat gun.
  • Repeat steps 2 & 3 until you have applied 3-4 coats. You should be able to see the colors begin to change as you are drying!
  • Once you have achieved your desired effect, seal with a tested Clear Coat. Epoxy Resin works best for projects. Gel Clear Coat works best for Nail Art.
  • Make sure ALL edges of Liquid Crystal® are thoroughly sealed to prevent peeling.

• Sprayable Concentrate - Best for use in Preval Spray Systems and other airbrushes with high PSI.
  • Start with a dry black surface.
  • Spray from about 1 foot away from your project to prevent droplets from gathering into drippage.
  • If needed, a small amount of filtered water can be used to dilute for better spraying. (Keep in mind that the more highly diluted it is, the more coats will be required for vivid color change.)
  • Apply a thin coat with even coverage.
  • Dry with hair dryer or heat gun.
  • Repeat previous 2 steps until 4-5 thin coats have been applied.
  • Once you have achieved your desired result, seal with clear epoxy resin.